The Use Of Electric Hydraulic Pump Jack And Maintenance Precautions

September 08, 2022

Electric hydraulic pump jack uses
1.Electric hydraulic pump can be used as a variety of hydraulic equipment hydraulic pump.

2. After the electric hydraulic pump and other hydraulic tools are equipped, it can carry out a great deal of work such as lifting, pressing, bending, bending, aligning, shearing, assembling and disassembling. Reduce labor intensity, improve work efficiency.

Use Electric Hydraulic Jack

Electric hydraulic pump jack Usage
Open the bleed nut when using, open the switch on the oil collecting block, plug in the power supply, and fasten the quick connector on the quick head equipped with hydraulic equipment. Press the power switch, until the motor rotates 1-2 minutes, the switch is closed at the supercharged state, the hydraulic oil output at this time will carry out various tasks, the output hydraulic oil with the increase of load self-pressurization of the work until 63MPA .

After the work, open the switch to unload until the hydraulic oil back to the end, remove the quick connector sleeve, spin a good deflated nut, unplug the power, the switch off.

Electric Hydraulic Jack Maintenance

Electric hydraulic pump jack maintenance precautions
1. The pump uses 20 oil.
2. Oil storage capacity must be within the oil window range.
3. Each refueling and oil change, must be more than 80 mesh filter oil filter, replace the need to wash the fuel tank. Oil change period of six months.
4. Working oil temperature 10 degrees Celsius to 50 degrees Celsius.
5. Before starting the electric pump, open the bleed nut and open the switch to unload position.
6. The process of using the motor temperature is too high, should be discontinued. Self-cooling before use.
7. The pump has been adjusted before leaving the factory, not free high-profile, to be readjusted, you must use the pressure gauge.
8. High-pressure tubing factory, after 105MPA test. However, due to easy aging hose, so the user should always check, usually six months, frequent use for three months, check 87.5MPA pressure test, if damaged, raised, leakage can not be used.
9. Bearings are generally cleaned once every six months, the assembly need to add grease.

The above is the The Use Of Electric Hydraulic Pump Jack And Maintenance Precautions we have listed for you. You can submit the following form to obtain more industry information we provide for you.

You can visit our website or contact us, and we will provide the latest consultation and solutions

Share to:

Send Inquiry

Next:How To Properly Install The Hydraulic Jack Filter